Product info

Horizontal system for down the hole hammer

The loads in Horizontal Drilling that the casing system must endure are severely higher than in typical vertical drilling. Robit® has developed a system which is capable of handling even the toughest conditions.
The Robit® HZ -system consists three parts; pilot bit, ring bit assembly with the ring bit and protective layer and impact shoe. The pilot bits hits directly the casing via the welded casing shoe. This causes that all the efforts of pulling the tube is diverted to the impact shoe and not on the ring. The ring bit is rotated with the pilot bit. This system leads to a longer life time of the ring bit, better penetration during drilling and increased reliability to finish the hole on time and according to plans.

Casing OD (mm)273
Casing OD (in.)10 ¾
Casing Max Wall (mm)12,7
Casing Max Wall (in.)0.500
Ring bit ID (mm)200
Ring bit ID (in.)7.874
Ring bit OD (mm)303
Ring bit OD (in.)11.929
Pilot bit OD (mm)245
Pilot bit OD (in.)9.646
Product number03-011-273-4420

Compatible products

DTH-RoX HZ 273/12,7
Pilot, Down the Hole Hammer, Horizontal drilling
DTH-RoX HZ 273/12,7
Impact Shoe, Down the Hole Hammer, Horizontal drilling